Notes & News

Keep cool this summer with DIY HVAC inspection

Having no heat in winter or no cool air in summer makes for a miserable time. Learn how to do a basic HVAC inspection that could always help keep your system operational.

You can stave off malfunctions and keep your HVAC system in good working condition by performing regular inspections.  Here are the steps to take when performing your very own HVAC inspection:

Start with the thermostat

Start by making sure your thermostat is working properly. Check that both the heating and cooling mechanisms turn on and off with their presets. Physically open the thermostat and carefully clean the device with a Q-tip.

Shut off the power

Find the correct switch on your breaker box and turn off power to the inside unit. On the outside unit, turn off the on/off switch. This is incredibly important, as you’ll soon be removing parts of the unit.

Remove debris from external HVAC unit

Grab a screwdriver and a wrench and detach the fan cage from the top of the unit. Using a wet/dry vacuum, remove any excess leaves or debris from the interior.

Clean and repair the fins

Take a sprayer hose and spray the fins from the inside of the unit, washing away any debris. Do not use a pressure washer, as that can be a little too powerful. If the fins are exceptionally dirty, you can find fin-cleaning spray at a local hardware store.

The fins need to be straight in order to keep airflow efficient throughout the year. Take a butter knife or a fin-straightening tool and straighten the fins carefully. Reattach the fan cage.

Clear the area around the unit

It’s a good rule of thumb to keep at least two feet of distance between your external unit and any shrubs, trees or other vegetation. During the winter months, it’s beneficial to put a piece of plywood or plastic on top of the unit to protect from falling debris.

Do not cover the unit, as that’s an invitation for vermin to move in during off months.

Level the unit

Just like your foundation, your external HVAC unit can shift overtime. A condenser that isn’t level can cause the compressor to fail much earlier than it should. Check if the unit is level, and if not, use rot-resistant shims to prop up whichever side needs it.

Clean the evaporator coil

Now head inside. On your internal unit, open the evaporator coil door and give it a good dusting. Then spray with commercially available no-rinse coil cleaner. This will turn into foam and drip into the drain pan, which then must be cleaned out with hot water, soap and a small amount of bleach.

Check the evaporator drain

You may notice that your interior unit’s evaporator drain is clogged, which can cause flooding and other issues. Using a wet/dry vacuum, suck out any debris in the drain that’s blocking the flow of runoff water.

Replace the filter regularly

One of the most common causes of HVAC malfunction is the filter. This is what traps debris from your HVAC unit, and if it’s not properly replaced regularly, it can create some major problems. Some say the filter should be replaced every six months, but every one to three months is ideal.

Final Steps

Inspect the duct work (where it’s visible) for any leaks and repair with duct tape.

Air vents should be in almost every room of your house. Unscrew each one and examine with a flashlight for any debris, including rodent feces or mold.

Corporate Office

Velocity Risk Underwriters, LLC
10 Burton Hills Blvd., Ste 300
Nashville, TN 37215
Get directions

Product or Policy Inquiries:

Personal Lines: (844) 878-7529
Small Commercial: (844) 878-7529
Large Commercial: (615) 942-0740